8
• Never attach an unapproved or a non-FOXPRO® charger to
your X24! Damages caused by plugging unapproved charging
devices into your X24 will not be covered by the warranty.
• Never connect your X24 to an unregulated 12V system (i.e.
automotive systems, high current power supplies, etc.) Serious
damage will occur which is not covered by the warranty. The
charge jack is intended only for FOXPRO® chargers.
• Do not mix battery types! For example: never use NiMH
rechargeable batteries in conjunction with non-rechargeable
alkaline batteries.
• Never attempt to charge batteries that are not intended to be
recharged! This includes both Zinc Carbon and alkaline cells.
The resulting damage can be serious and will not be covered by
the warranty. For maximum charge efficiency, we recommend
charging your X24 in temperatures ranging from 40°F to 85°F
(5°C to 30°C).
• Disconnect any/all accessory devices that may be attached to
the X24 prior to charging. This includes external speakers,
auxiliary devices, and USB cables.
• Make sure that the rechargeable battery pack is installed in the
X24 properly.
• Connect the approved FOXPRO charger to the charger jack on
the X24 and attach the transformer to the appropriate outlet.
• Do not leave charging batteries unattended.
• Remove batteries from battery holder when caller will not be
used for prolonged periods to help prevent deep discharge.
• Recharge your batteries periodically—even when not in use—to
prevent deep discharge.
2. X24 Remote: First Glance
The following chart corresponds to a graphic on the next page that
depicts the X24 remote. Certain aspects of the X24 remote will be
To Next Page
Loading...
