16
4-4 Auxiliary Device Jack
The AUX jack is provided primarily for the control of FOXPRO decoys
and may be suitable for controlling other similar devices. It is NOT
intended for the direct control of motors, flashlights, or other devices
requiring the internal AUX jack circuitry to switch more than 50
milliamps. The jack tip polarity is positive. Do not exceed 15 volts. You
are urged to seek help from a knowledgeable professional before
connecting any unapproved device to the jack. Keep in mind that any
damage to the FOXPRO caller because of improper use of the AUX jack
is not covered by the warranty, nor will FOXPRO be liable for damage to
any connected devices.
4-5 USB Port
The X24 is equipped with a USB port which is located inside of the
battery compartment. To gain access to the USB port, you must remove
the battery compartment cover and battery pack from the caller. To
Connect the X24 to a Computer Make sure that the X24 is turned off.
Connect one end of your USB cable to the USB port in the X24. Connect
the other end of the USB cable to a USB port on your computer. On
most major operating systems, you will hear an alert as well as see
visual notification on the screen that a new device has been attached.
4-6 Setting the Channel of Operation
Changing the channel of operation requires that you remove the
battery compartment cover from the X24 and modify the values of a
DIP switch located inside. There are 8 channels of operation available (0
– 7). The default channel of operation set at the factory is 6.
Changing the Channel of Operation
Remove the battery compartment cover. Locate the cutout in the top,
right-hand side of the battery compartment. (See image below) The DIP
switch has 4 individual slide switches. Each switch has two positions. To
change the channel, however, you will only modify switches 1 – 3. The
To Next Page
Loading...
