41
Ample instructions are present on the website to aid you in the update
process. You are welcome to contact FOXPRO technical support for
assistance in this matter.
Begin by verifying that the batteries in your FOXPRO TX1000 remote are
fresh or fully charged. It is crucial that the batteries are fresh or fully
charged prior to starting this process. If the batteries are weak and
cause the device to lose power during the update process, the device
could be damaged to an extent where it is no longer usable. Again,
make sure your batteries are fresh or fully charged and then follow the
instructions below:
Turn off the TX1000. Open the update utility software. Push and hold
the user button on the bottom left of the remote. While holding in the
user button, turn the remote on. You will observe a screen displaying:
“FOXPRO TX1000 FIRMWARE UPGRADE CONNECT USB CABLE START
UPGRADE UTILITY”. Connect the USB cable from the TX1000 to the
computer. Push the ‘Connect’ button on the utility to start the update.
When complete, disconnect the TX1000 from the computer and turn it
on. You should now see the new firmware version number.
15. Product Care & Maintenance
To help get years of trouble-free service with your FOXPRO game call, it
is strongly recommended that you read and understand the following
points. Many of these are considered proactive or preventative.
• Avoid exposure to all precipitation and moisture.
• Remove batteries prior to storage or extended periods of
inactivity!
• Periodically charge your rechargeable batteries when not in use!
• Keep it clean!
• Store in a dry location!
• Check it out before heading into the field!
To Next Page
Loading...
