29
Assigning a feature to FOXGRIP:
Access the FOX FEATURES menu and locate the FOXGRIP menu item.
Push the “Play/Select” button and then use the scroll buttons to cycle
through the available options. If using a Fox Grip 1, you will only adjust
Button 1. If using Fox Grip 2, you can adjust the setting for both
buttons. After locating the desired option, push the “Play/Select”
button to lock it in.
7. Sound Settings
This chapter explores the sound settings menu and all associated
options.
7-1 Volume Step
The X24 remote has a range of volumes from 0 – 40. Increasing the
volume in the field by increments of 1 may be too slow for some and
therefore this stepping value is configurable. You can choose from 1, 2,
3, and 5. The factory default setting is 2.
7-2 Pri. Mode
Allows you to specify how the sounds are played back. The default
value is repeat, where the sound will play continuously when the end of
the sound has been reached by starting over. Single mode will result in
each sound being played a single time. Juke represents ‘jukebox mode’
where after a sound has played, it will automatically move on to the
next sound in the list.
7-3 Spk Mode (Speaker Mode)
There are three speaker modes available for you to select from. These
modes affect how sounds are played through the speakers. The modes
are Stereo, Reverse Stereo, and Mono.
By default, the device will be setup for stereo speaker mode. As the
X24 has a single speaker setup a stereo audio file will be split so that the
To Next Page
Loading...
