33
going to go off 20 minutes later unless you use the Stand Timer Reset
prior to setting the alarm. Also, if the screen timeout occurs prior to the
alarm going off, it will turn back on when the alarm goes off.
Setting the Alarm:
Access the Date/Time(r) menu and select “Alarm.” Use the scroll
buttons to select the desired amount of time in minutes. To shut off the
alarm, simply change the value to off. Push “Play/Select” to set the
alarm.
9-3 Time
The X24 remote has a real time clock. This clock must be set when you
first install or change batteries. The clock can be displayed in either the
standard 12-hour format or 24-hour format (military time). The bottom
status line of the X24 display can show either the current time or the
stand timer. The stand timer will only be displayed if it is turned on—
otherwise, the clock will show the current time.
9-4 Date & Date Format
The X24 remote will keep track of the current date to properly render
moon phases. These needs setup when you first start using the X24
remote. The X24 remote control features a moon phase indicator. To
display the correct moon phase, it is imperative that you enter the
correct date. Otherwise, the displayed information may not be correct.
10. TX1000 Settings
The TX1000 Settings menu allows you to change the radio channel,
download the sound list, and configure other options.
10-1 Radio Channel
The X24 remote can be configured to operate on one of 8 different
radio channels (0-7). If you change the radio channel for the X24
remote, you must also change the radio channel for the X24 digital
game call—otherwise the two devices will not be able to communicate.
To Next Page
Loading...
