39
V 20
S 15 4
D 1
P 90
V 35
D 0
S 22
V 30
S 20 3
Q
The previous example is interpreted as follows: Set volume to level 20.
Play sound number 15 a total of 4 times. Activate the decoy. Pause for
90 seconds. Adjust volume to level 35. Deactivate the decoy. Play sound
number 22. Adjust volume to level 30. Play sound number 20 a total of
3 times. Quit.
Notice that you can specify how many times you wish a particular
sound to be played. By entering your instruction as “S 20 3”, you are
thereby instructing the unit to play sound 20 a total of three times.
A FOXCAST sequence must always begin with a volume or pause.
Without defining a volume level, the caller will default to volume level
0. A FOXCAST sequence file must always end with a specific ending
statement. “J” represents jukebox mode. When you end a sequence
with “J”, once the sequence has played through a single time, it will
automatically begin playing the next FOXAST sequence. “Q” represents
quit. Once the sequence has played entirely, the X24 will go silent. “R”
represents repeat. Once the sequence has been played entirely, the X24
will play that sequence again until it is interrupted by the operator. The
X24 can accept up to 20 FOXCAST sequence files. These files will need
to be in a format such as “S00 My Coyote Sequence.seq”.
To Next Page
Loading...
