freightliner 122SD - Cab-To-Sleeper Access; Sleeper Exit Door

3.
Move your left hand to the lower grab handle
located at the rear edge of the door opening.
See
Fig. 2.4.
4.
Move your right hand to the integral door lower
grab handle.
5.
Step to the ground with your right foot first.
Cab-to-Sleeper Access
To open the sleeper access on vehicles with vinyl
sleeper curtains, unzip the sleeper curtains. If de-
sired, unsnap the curtains all the way around the
sides and top, and remove the curtains.
To open the sleeper access on vehicles with velour
sleeper curtains, unfasten the snaps at one side,
then push the curtain to the opposite side.
Sleeper Exit Door
The sleeper door (Fig. 2.5) is not intended for entry
or exit. The door is intended only as a convenient
means to stow or remove personal belongings in and
from the sleeper area. To open the door from inside,
push down on the lever handle located inside the
sleeper compartment to the right of the door. The
door can be opened from the outside by first opening
the baggage door, then pulling the release cable
strap just inside on the left of the baggage door
opening. To close the door, push it closed until it
latches.
09/24/2009 f602391
1
2
3
4
1. Lower Grab Handle
2. Upper Grab Handle
3. Integral Door Upper Grab Handle
4. Integral Door Lower Grab Handle
Fig. 2.4, Passenger-Side Steps and Grab Handles
f602392
1
2
09/21/2009
1. Sleeper Door
2. Luggage Compartment Door
Fig. 2.5, Sleeper Doors
Vehicle Access
2.3