6.
Fore-and-Aft Seat (seat track adjustment): The
entire seat moves forward or backward when this
adjustment is made.
7.
Seat Tilt: When this adjustment is made, the seat
assembly (back and bottom cushions) tilts for-
ward or backward.
8.
Upper Back Cushion Adjustment: When this ad-
justment is made, the upper back cushion
changes angle to provide upper back support.
9.
Weight Adjustment: On those seats with weight
adjustment, the feature is fully automatic. When
you sit on the seat, a leveling valve places you in
the center of the ride zone. Additional adjust-
ments are possible by using the height adjust-
ment feature.
Freightliner High-Back Seat
See Fig. 6.2 for seat adjustment controls. Not all
models of the seat have all the adjustments listed
below.
Backrest Tilt
To tilt the backrest, lean forward slightly to remove
pressure from the cushion, then turn the knob for-
ward or rearward to achieve the desired position.
Lumbar Support
To adjust the lumbar support, use the lumbar support
switches on the side of the seat.
Height Adjustment
To raise or lower the height of the seat, use the
height adjustment switch on the side of the seat.
Bottom Cushion Extension
To adjust the fore-and-aft position of the seat cush-
ion, remove your weight from the seat, then lift up
and pull forward on the cushion adjustment handle.
To return the cushion to the aft position, lift up and
push rearward.
Fore/Aft Seat Slide
To adjust the fore-and-aft position of the entire seat,
move the fore-and-aft seat adjustment lever to the
left and slide the seat forward or backward to the
desired position. Move the lever back to its original
position to lock the seat in place.
Fore/Aft Isolator
To engage the isolator, turn the isolator knob rear-
ward to the unlocked position. Turn the isolator knob
forward to the locked position when the isolator fea-
ture is not desired.
Shock Absorber
To adjust the amount of damping the shock absorber
provides, move the lever up to increase damping;
move the lever down to decrease damping.
Front Cushion Height
To adjust the height of the front of the cushion, re-
move your weight from the seat, then turn the adjust-
ment knob toward the front of the seat (clockwise) to
increase cushion height. To lower the cushion height,
turn the adjustment knob toward the rear of the seat
(counterclockwise).
Rear Cushion Height
To adjust the height of the rear of the seat cushion,
remove your weight from the seat and turn the rear
cushion adjustment knob to one of three positions.
Heater
To turn on the heat option, press the button. To turn
off the heat option, press the button again. If the ve-
hicle has Optimized Idle, seat heating will not oper-
ate with the key in accessory mode. Optimized Idle
may also turn seat heating off to reduce stress on
the batteries. Refer to
Chapter 10 for more informa-
tion about Optimized Idle.
EzyRider® Seat
For EzyRider seat adjustment controls, see Fig. 6.3.
Back Cushion Tilt
To tilt the back cushion, raise the back cushion tilt
lever and lean forward or backward. Release the
lever to lock the cushion in place.
Seats and Restraints
6.2
To Next Page
Loading...
