will display in degrees Fahrenheit if MI is selected in
the setup screens, or degrees Celsius if KM is se-
lected.
Service Warnings
Service warning screens display during the ignition
sequence and indicate that a service interval has
been reached or exceeded and maintenance is re-
quired. The messages may indicate the number of
miles (KM) or hours until the next required service or,
once passed, the number of miles (KM) or hours ago
that maintenance should have been performed.
Automated Transmission Display
The ICU4M can display current gear information for
vehicles with an automated transmission. The last
three digits at the far right on the lower line of the
driver display screen are reserved for this informa-
tion.
If there is a request to shift, an up or down arrow is
also displayed, depending on the shift direction.
On vehicles with conventional manual or automatic
transmissions, the gear and shift direction are not
displayed. For more information about specific
models of automated transmissions, see
Chapter 14.
Direct Access Screens
When the parking brake is not set, pressing the
mode/reset button or the +/- INFO switch will scroll
through the direct access screens. See
Fig. 4.12.
•
Fasten seat belt (rpm<100)
•
Fuel economy (rpm>100)
•
Trip distance/hours
•
Trip advisory
•
Leg distance/hours
•
Leg advisory
•
Fuel used/average MPG (KM/L)
•
Outside air temperature
Favorite Screen
The driver can access a preset favorite direct access
screen using the MY INFO switch. Holding down the
lower half of the MY INFO switch for just over one
second will set the current screen as the favorite
screen. A chirp will sound to verify the screen has
been set. Only direct access screens can be se-
lected as the favorite screen.
The favorite screen can be called up by pressing the
lower half of the MY INFO switch. The favorite
screen can be accessed with the parking brake off or
on. There is no time-out for this screen. The screen
can be acknowledged by pressing the +/- INFO
switch.
Stationary Access Screens
When the parking brake is set, pressing the mode/
reset button or the +/- INFO switch will scroll through
the stationary access screens.
•
Trip information including trip miles/hours, idle
hours, average speed, leg miles/hours
•
Fuel information including fuel used, fuel
economy, idle/PTO fuel usage
•
Engine information including engine miles/
hours, engine/PTO gallons, oil level
•
Diagnostic information
•
Service information including mileage or time
to next service
•
Setup information
•
Vehicle information including Datalink status,
ICU serial number, software version
•
Fasten seat belt warning (rpm <100)
•
Idle hours rpm >100)
•
Outside air temperature
Use the +/- INFO switch to scroll through the menus
and press the MY INFO switch to advance to the
sub-menus. Hold the upper half of the +/- INFO
switch to reset the counters for trip and fuel informa-
tion.
Vehicle Information Screens
The vehicle information screens display hardware
and software information, including the Freightliner
part number and switch ID of the ICU. See
Fig. 4.13.
Trip Information
When idle hours is displayed, press the +/- INFO
switch or the MY INFO switch to display the main trip
information screen. See
Fig. 4.14.
Instruments
4.17
To Next Page
Loading...
