➥ Inform the installer or Froling customer service.
In the event of a power failure proceed as follows:
❒
Keep all the doors on the boiler closed.
❒ The boiler controller will start again automatically after the restart.
➥ Half an hour after the boiler restart, compare the values in the boiler controller
and the values on the pressure gauges with the original values. If the pressure
level is too low, add water to the heating system in accordance with the heating
installer's instructions.
In the event of excessive temperature the high-limit thermostat may have triggered.
You may have to release this to allow the boiler to restart.
What to do if there is a smell of flue gas
If you smell flue gas, proceed as follows:
❒ Keep all the doors on the boiler closed.
❒ Ventilate the boiler room where the boiler is located.
❒ Close the fire door and doors to living areas.
What to do in the event of fire
In the event of a fire proceed as follows:
❒ Keep all the doors on the boiler closed.
❒ Leave the main switch switched on.
❒ Close the fire door
❒ Leave the boiler room and the building.
❒ Inform the fire department.
1.7 Staff requirements
Risk of injury from inadequate qualification of staff!
WARNING
Risk of injury from inadequate qualification of staff!
If unqualified staff work on the system, or are within the danger zone of the
system, this creates hazards which could cause serious injuries and considerable
damage to property.
❒ All such activities should be carried out only by suitably qualified staff.
❒ Keep unqualified staff away from danger zones.
Definition of staff qualifications
The staff qualifications listed here for the United States are based on the descriptions
of professional qualifications in the Occupational Outlook Handbook 2011-12 edition of
the United States Department of Labor, Bureau of Labor Statistics.
Operator
The operator is the person who operates the heating system for commercial or
economic purposes by himself or cedes use/application to a third party and bears the
legal responsibility concerning the product for the protection of the user or third parties
during the operation.
Safety
1
Staff requirements
Montageanleitung S3 Turbo | M1870119_en-us 25