Froling S3 Turbo Assembly Instructions

3.3.1 Remove boiler from pallet 36
3.3.2 Moving the boiler in the boiler room 36
3.3.3 Space required 37
3.4 Before Installation 37
3.4.1 Changing door stops (as needed) 37
Converting the fuel loading door 39
3.4.2 Fitting the door handles 40
3.4.3 Set and check the seal on the doors 40
Adjusting the doors 42
3.5 Installing the boiler 43
3.5.1 Assembly overview 43
Insulation 43
Air duct system 45
WOS system S3 Turbo 30 46
EOS system S3 Turbo 50 47
3.5.2 Fit flue gas pipe nozzle and the induced draught fan 48
3.5.3 Installing the pneumatic rods for the primary and secondary air 48
3.5.4 Final steps before insulating 50
3.5.5 Installing the insulation 50
3.5.6 Fitting the door contact switch 53
3.5.7 Installing the back panel 53
3.5.8 Aligning the insulation and attaching the controller 54
3.5.9 Installing the cleaning door and blank cover 56
3.5.10 Installing the insulated door 56
3.5.11 Fitting the sensors 59
3.5.12 Fit the broadband probe 60
3.5.13 Installing the WOS system 61
3.5.14 Installing the servo-motors 62
3.6 Power connection and wiring 63
3.6.1 Wiring the ID fan 64
3.6.2 Wiring 64
3.6.3 Information on circulating pumps 65
Connecting a squirrel cage standard pump 65
Connecting a high efficiency pump 66
3.6.4 Final installation steps 67
4 Start-up 68
4.1 Before commissioning / configuring the boiler 68
4.2 Initial startup 69
4.2.1 Permitted fuels 69
4.2.2 Non-permitted fuels 70
5 Decommissioning 71
5.1 Mothballing 71
5.2 Disassembly 71
5.3 Disposal 71
6 Appendix 72
6.1 Hydraulic diagram 72
6.2 Addresses 73
6.2.1 Address of manufacturer 73
6.2.2 Address of importer 73
6.2.3 Address of Local Dealer 73
Table of Contents
Montageanleitung S3 Turbo | M1870119_en-us 3

Froling S3 Turbo Specifications

General

Brand	Froling
Model	S3 Turbo
Category	Boiler
Language	English