Operation manual P328S
© 2018 FROMM Holding AG 9
All rights reserved. Reproduction and duplication - also in extracts - are not permitted.
Work menu / Operation mode
The strapping tool can be operated in the work menus CLASSIC or ADVANCED.
Both work menus each enable manual, semi-automatic, or automatic operation modes.
Strap tension
Strap tension*: Can be set from 250 - max. 2600 N / 56 - max. 585 lbs.
The adjustment is made in 5% increments.
Strap speed*: 49-174 mm/s / 1.9 - 6.8 inch/sec.
The strap speed depends on the strap tension. In the lowest tension this is 49 mm/s
(1.9 inch/sec), this increases up to 70% of the tension to 174 mm/s (6.8 inch/sec)
and then remains at this level up to the highest setting.
Strap material
Strap qualities: PET (Polyester) and PP (Polypropylene) plain or embossed.
The plastic strap must be according to DIN EN 13394.
Use only plastic straps recommended by your sales shop (name and address
on the rear of the operation manual).
Strap dimensions: 12.0 - 16.0 mm x 0.40 - 1.05 mm (see chart of types).
Use only plastic straps with the correct strap dimensions for your tool.
Seal
Type of seal: Friction weld sealing
Strength of seal*: approx. 75% of the tensile strength of the plastic strap.
* The value depends on the strap quality.
Working temperature
The ambient temperature should be between -15° and 45° C (5° and 113°F).
The best performance is achieved between 15° and 20°C (59° and 68°F).
Data transmission for tools with activated remote module
Signal reach up to approx. 30 m.
The mobile terminal equipment must have Bluetooth® 4.2 low-energy or higher.
Depending on the external requirements, including the receiver, this reach can vary strongly. Inside closed
rooms and behind metal barriers (such as walls, shelves, suitcases, etc.), the reception distance can be
considerably shorter.
Bluetooth® is a registered trade mark and property of Bluetooth SIG, Inc.
Operation
mode
CLASSIC work menu
ADVANCED work menu
Manual The tool user starts the tensioning and sealing
of the strap.
The tool user starts the tensioning and sealing
of the strap.
The strap speed is variable.
Semi-
automatic
The user presses the tension key until the set
tension is reached. The sealing starts
automatically when the set tension is reached.
The user presses the tension key until the set
tension is reached.
The strap speed is variable.
The sealing starts automatically when the set
tension is reached.
Automatic The user taps the tension key to start the
automatic tension and sealing procedures.
The user taps the tension key to start the
automatic tension and sealing procedures.
To Next Page
Loading...
