ud_fr_st_sv_00467 012010
IX
Shielding-gas cylinders contain pressurized gas and may explode if they are
damaged. As shielding-gas cylinders are an integral part of the overall
welding outfit, they also have to be treated with great care.
Protect shielding-gas cylinders containing compressed gas from excessive
heat, mechanical impact, slag, naked flames, sparks and arcs.
Mount the shielding-gas cylinders in the vertical and fasten them in such a
way that they cannot fall over (i.e. as shown in the instruction manual).
Keep shielding-gas cylinders well away from welding circuits (and, indeed,
from any other electrical circuits).
Never hang a welding torch on a shielding-gas cylinder.
Never touch a shielding-gas cylinder with a welding electrode.
Explosion hazard - never perform welding on a pressurized shielding-gas
cylinder.
Use only shielding-gas cylinders that are suitable for the application in
question, together with matching, suitable accessories (pressure regulators,
hoses and fittings, ...). Only use shielding-gas cylinders and accessories that
are in good condition.
When opening the valve of a shielding-gas cylinder, always turn your face
away from the outlet nozzle.
Close the shielding-gas cylinder valve when no welding is being carried out.
When the shielding-gas cylinder is not connected up, leave the cap in place
on the shielding-gas cylinder valve.
Observe the manufacturer’s instructions and all relevant national and
international rules applying to shielding-gas cylinders and accessories.
Danger from
shielding-gas
cylinders
Particular danger
spots
(continued)
When hoisting the machines by crane, only use suitable manufacturer-
supplied lifting devices.
- Attach the chains and/or ropes to all the hoisting points provided on the
suitable lifting device.
- The chains and/or ropes must be at an angle which is as close to the
vertical as possible.
- Remove the gas cylinder and the wirefeed unit (from MIG/MAG and TIG
units).
When hoisting the wirefeed unit by crane during welding, always use a
suitable, insulating suspension arrangement (MIG/MAG and TIG units).
If a machine is fitted with a carrying strap or carrying handle, remember that
this strap is ONLY to be used for lifting and carrying the machine by hand.
The carrying strap is NOT suitable for transporting the machine by crane,
fork-lift truck or by any other mechanical hoisting device.
Danger of colourless and odourless inert gas escaping unnoticed, when
using an adapter for the inert gas protection. Seal the adapter thread for the
inert gas connection using Teflon tape before assembly.
To Next Page
Loading...
Need help?
General
