29
EN
Safety
Safety Observe the following safety rules for all work described in the "Installation and start-up"
section.
WARNING!
Incorrect operation or poorly executed work can cause serious injury or damage.
All activities described in these operating instructions may only be carried out by trained
and qualified personnel. All functions described in these operating instructions may only
be used by trained and qualified personnel. Do not carry out any of the work or use any of
the functions described until you have fully read and understood the following documents:
► these operating instructions
► all the operating instructions for the system components, especially the safety rules
WARNING!
Machines that start up automatically can cause serious injury and damage.
In addition to these operating instructions, the safety rules issued by the manufacturer of
the robot and welding system must also be observed. For your personal safety, ensure that
all protective measures have been taken and will remain in place while you are in the work-
ing area of the robot.
WARNING!
Risk of serious injury from:
► mechanically powered components
► flying parts (shavings, etc.)
► compressed air escaping from the cleaning nozzles
► Before performing work on the cleaning device or any connected system components:
► disconnect the customer's compressed air and power supplies from the cleaning de-
vice and the connected system components, and ensure that they remain disconnect-
ed until work is complete
► ensure that the cleaning device is depressurised - please see the "Ensuring that the
cleaning device is depressurised" section below for the relevant instructions
WARNING!
Whenever the cleaning device and connected system components are supplied with
voltage and/or compressed air, a risk of serious injury exists from:
► rotating brush head
► lifting device moving up/down
► activated wire cutter
► flying parts (shavings, etc.)
► compressed air escaping from the cleaning nozzles
If work has to be performed on the cleaning device while it is being supplied with voltage
and/or compressed air:
► keep your body, especially your hands, face, hair, tools and all clothing away from the
brush head, brush head lifting device, wire cutter and cleaning nozzles
► wear ear protection
► wear protective goggles with side protection
To Next Page
Loading...
