40
Adjusting the position of the cleaning motor (with
Braze+ brush head)
Adjusting the po-
sition of the
cleaning motor
Remove the protective covering from the cleaning device
Ensure that the lifting device (1) is in its lowest position
Move the welding torch to the cleaning position
Loosen screw (2) on the lifting device
(1)
Manually push the lifting device (1) into
its highest lift position and hold in place
Manually push the cleaning motor (3)
and brush head (4) into the cleaning
position
Fix the cleaning motor (3) in this position in the lifting device (1) - tighten the screw (2)
on the lifting device (1)
Fit the protective covering to the cleaning device in its original position
1
2
3
(2)
(1)
(3)
(4)
4
5
6
7
8
To Next Page
Loading...
