47
EN
Starting up the cleaning device
Prerequisites for
start-up
The following requirements must be met before the cleaning device is started up:
- If present, the cleaning device installation stand is screwed to the underlying surface
- The cleaning device is screwed to the underlying surface
- Brush head is fitted
- Position of the cleaning motor has been set
- Compressed air supply has been established
- Functions have been checked manually
- Cleaning device is connected to the robot control
- All coverings are fitted and all safety devices are intact and in their proper place
Start-up The cleaning device starts up when there is an active signal from the robot control.
To Next Page
Loading...
