Fronius Robacta Reamer - Cleaning Program Sequence

49
EN
Cleaning program
sequence
Move to pos. C
- approx. 25 mm (0.98 in.) next to the
wire cutter
- Speed: high speed
Query - cleaning
motor lowered
'High'
Wait 0.5 s
Move to pos. D
- Enter
wire cutter
- Speed: 60 cm/min
(23.62 ipm)
Start
Stop program
- Cleaning motor not lowered
Move to pos. A
- approx. 50 mm (1.97 in.) centrally
above brush head
- Speed: high speed
'Low'
Move to pos. B
- Move to
cleaning position
- Speed: 60 cm/min
(23.62 ipm)
Wait 3 - 5 seconds
Set
- 'Start cleaning' signal
Wire cutter option