34
Adjusting and fitting the standard brush head
General
NOTE!
The following information applies to the use of the manufacturer's contact tips, gas
nozzles and brush head.
If other manufacturers' products are used, trouble-free operation of the device cannot be
guaranteed. The manufacturer accepts no liability for damage arising from the use of other
manufacturers' contact tips, gas nozzles or brush heads.
The brush head has two different settings
(A and B) to modify the distance between
the diagonal brushes according to the type
of gas nozzle being used.
NOTE!
The following list of settings is intended as a guide only.
Setting A for:
standard gas nozzles with an outer diameter up to 23 mm (0.91 inch)
Setting B for:
standard gas nozzles with an outer diameter from 24 mm (0.95 inch) upwards
Adjusting the
brush head
Adjust the brush head as follows:
To Next Page
Loading...
