59
EN
Changing the di-
agonal brushes
NOTE!
In the process described below for changing a diagonal brush, a standard brush
head is shown.
The process is identical for aBraze+ brush head.
NOTE!
Before changing the brushes, note the setting of the brush head (A or B) and be sure
to use this setting during assembly.
This will ensure that the correct clearance is maintained between the diagonal brushes af-
ter the brush has been changed.
Remove the protective covering from the cleaning device
11 12
13
Fit the protective covering to the cleaning device in its original position
Disposal Dispose of in accordance with applicable national and local regulations.
1
2 3
4
5
To Next Page
Loading...
