Parameters for
TimeTwin Digital
in the Setup
menu level 2
T-C
Twin Control - for defining the leading or trailing power sources in the TimeTwin Digital
process
Unit -
Setting range On (Leading power source), OFF (Trailing power source)
Factory setting -
The T-C parameter is only available when two power sources are connected via an
LHSB (LocalNet High-Speed Bus) and the “TimeTwin Digital” option has been enabled.
NOTE!
When a robot interface is connected to the power source, the T-C parameter can
only be adjusted via the robot interface.
Parameters for
TIG welding in
the Setup menu
level 2
C-C
Cooling unit control
Unit -
Setting range AUT, ON, OFF
Factory setting AUT
AUT: The cooling unit cuts out after a 2-minute welding off-time
NOTE!
If the “FK 4000 thermostat” option has been installed in the cooling unit, the cool-
ing unit cuts out as soon as the return temperature has dropped below 50°C, but
no sooner than after a 2-minute welding off-time.
ON: The cooling unit is permanently ON
OFF: The cooling unit is permanently OFF
If an FK 9000 cooling unit is used, the only possible settings are ON and OFF.
NOTE!
Parameter C-C can be set differently for MIG/MAG welding and TIG welding.
Example:
- MIG/MAG welding process ... e.g. use of a water-cooled welding torch: C-C = AUT
- TIG welding process ... e.g. use of a gas-cooled welding torch: C-C = OFF
CSS
Comfort stop sensitivity - Sensitivity of the response characteristic of the TIG comfort
stop function
Unit -
Setting range 0.5 - 5.0 or OFF
Factory setting OFF
157
EN
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
Need help?
General
