Fronius TTB 80 G - Connecting the Extension Hosepack; Connecting the Water-Cooled Extension Hosepack

Connecting the extension hosepack
Connecting the
water-cooled ex-
tension hosepack
The extension hosepack comes with a protective bag in which the interface connecting
the extension hosepack to the torch hosepack is placed.
NOTE!
When carrying out the work described
below, ensure that the cables and ho-
ses are not kinked, pinched, abraded or
otherwise damaged.
NOTE!
Risk due to damaged O-ring on the welding torch connection.
A damaged O-ring on the welding torch connection can lead to contamination of the
shielding gas, resulting in a defective weld.
▶
Before each start-up, ensure that the O-ring on the welding torch connection is un-
damaged.
2
1
3
Connect the welding torch to the interconnecting hosepack
1
Fit protective bag, lay coolant hoses:
2
Position the protective bag as follows:
- the Fronius logo must be visible
- the loops of the protective bag must be at the top
Notes on the following diagrams:
left = power source end (A)
right = welding torch end (B)
70