Changing the torch body of a water-cooled welding
torch
Automatic empty-
ing of the welding
torch and chan-
ging the torch bo-
dy
CAUTION!
Danger from switched on power source during automatic emptying of the welding
torch.
Unintentional arc ignitions can occur.
▶
Follow the instructions for automatic emptying of the welding torch in the cooling unit
Operating Instructions, the power source Operating Instructions, and on the power
source control panel.
▶
When carrying out the work on the torch body as described below, keep at least 1 m
(39.37 in.) away from electrically conductive objects.
Empty the welding torch automatically (e.g., with CU 600t /MC) and remove the
torch body:
1
Empty the torch hosepack using the corresponding cooling unit function
2
3
80
To Next Page
Loading...
Need help?
General
