Fronius TTB 80 G - Fitting a P-Type Wearing Part with Gas Nozzle (Screw Type)

Fitting a P-type
wearing part with
gas nozzle (screw
type)
CAUTION!
Risk of damage due to excessive tightening torque on the fixing sleeve (1) or gas
lens (2).
Damage to the thread may result.
▶
Only tighten the fixing sleeve (1) or gas lens (2) a little.
* Replaceable rubber sealing sleeve only for TTB 220 G/P
** A gas lens (2) may be used instead of the fixing sleeve (1) depending on the type
of welding torch
1
2
3
4
5
6
1
2
3
*
2
3
4
1
(2)**
(1)**
4 / 5
2
CAUTION!
Risk of damage due to excessive tightening torque on the torch cap.
Damage to the thread may result.
▶
Only tighten the torch cap enough so that the tungsten electrode can no longer be
moved by hand.
2
30°
1
3
d
d
d
1
2
3
Screw down the torch cap
4
62