4
CAUTION!
Danger due to incorrectly fitted torch body.
This can result in damage to property.
▶
Ensure that the locking device is fully forward after fitting the torch body - only then
is the torch body properly fitted and locked.
5
Connect the power source to the grid and switch on
6
Press the gas-test button on the power source
Shielding gas flows out for 30 s.
7
Check the coolant flow:
You must be able to see a strong return flow into the cooling unit coolant container.
8
Perform a test weld and check the quality of the weld
85
EN-US
To Next Page
Loading...
Need help?
General
