-
Choose car: For activating the optimised standard settings of different
vehicle models.
-
Minimum current: Some cars will not resume charging after an interruption.
To prevent an interruption, the minimum charging current can be set.
-
Forced charging interval: In the case of cost-optimised charging, the Wattpi-
lot interrupts the charging process if the electricity price is too high. Some
cars will not tolerate interruptions and will not continue charging after pro-
longed interruptions to the charging process. In this case, the charging pro-
cess must be started regularly for a short time.
-
Allow charging pause: Some cars will not resume charging after an interrup-
tion. Charging interruptions are prevented if this option is deactivated.
-
Simulate unplugging: Some cars need to be disconnected for a while if there
has been an interruption during cost-optimised charging. This function simu-
lates a disconnection before charging continues.
-
Charging pause: Some cars require a certain amount of time after an inter-
ruption to charging before they can start charging again.
-
Minimum charging time: Set the minimum time for which the car must be
charged after charging starts.
-
Choose phase switch:
-
Automatic: A power level can be set, from which 3‑phase charging takes
place. If "0" is set, the Wattpilot immediately starts 3‑phase charging.
-
Only 1‑phase: There is 1 phase available for charging.
-
Only 3‑phase: There are 3 phases available for charging.
-
3‑phase power level: Set a power level that must be reached by the photo-
voltaic system before the Wattpilot switches from 1‑phase to 3‑phase char-
ging. If the available power is greater than the set value, the Wattpilot imme-
diately activates 3‑phase charging. Automatic switching can be deactivated in
the car settings.
-
Phase switch delay: Phase switching is performed when the "3-phase power
level" is permanently exceeded or undercut during this period.
-
Phase switch interval: Minimum time between phase switching.
NOTE!
If a vehicle to be charged is not listed, no specific charging behaviour is known.
All defaults can be customised.
▶
Select the standard charging behaviour.
Charging timer The "Charging timer" setting limits charging to specific times. A start and end
time must be specified for this. Several time windows can be set. The following
can be set:
-
The time (start and end time) and
-
The days of the week.
NOTE!
Verhalten bei aktiviertem Eco Mode or Next Trip Mode:
If charging is not allowed by the charging timer for a certain period of time, Eco
Mode and Next Trip Mode are also blocked for this period.
If the charging timer does allow charging in a certain period of time but the set-
tings for Eco Mode or Next Trip Mode are not met, charging will not occur.
Name Change the name of the paired Wattpilot.
51
EN
To Next Page
Loading...
Need help?
General
