Image Quality Trouble
241
Is the paper tray inserted
correctly?
Firmly push in the tray until it stops to insert it
properly.
Part of the image
is missing on the
copy.
Is the paper damp? If the paper is damp, the copy image may be
partially missing or unclear. Replace the
paper with a new one.
Is folded or wrinkled paper
included in the tray?
Remove the unsuitable paper or replace all of
the paper with a new one.
Is the document pasted or
folded?
The pasted or folded section may not be
laying flat on the document glass. Place a
stack of white sheets on top of the document
to flatten the document against the
document glass.
The copy has a
stripe pattern.
Is the enlargement ratio too
large?
Vertical stripes may be printed on the copies
depending on the ratio. Adjust the ratio to
eliminate the stripes.
Color shift of
color copies is
poor, resulting in
unsatisfactory
image quality.
Is the color calibration
incorrect?
Execute auto calibration.
z
Refer to "Executing Combined Calibration" (P.149) .
Is the device set where it is
exposed to direct sunlight?
If the document glass is exposed to strong
light when you turn the device on or cancel
the Power Saver mode, color shift may occur.
Close the document cover and turn the device
on, and when the device becomes ready to
copy or print, turn the device off and then on
one more time.
Printing is faint.
(smudged,
unclear)
The paper is damp. Replace the paper with new one.
The drum cartridge has
deteriorated or is damaged.
Replace the drum cartridge with a new one.
There is no toner left in the
toner cartridge.
Replace the toner cartridge with a new one.
z
Refer to "Replacing Toner Cartridge" (P.122).
Symptom Cause Remedy
To Next Page
Loading...
Need help?
General
