2 Product Overview
38
4 Booklet tray (Right-Bottom Output Tray)
Outputs the paper.
z
Attached when using Finisher D6 with Booklet Maker. When SquareFold Trimmer D1 (optional) is installed,
attached to the SquareFold Trimmer D1 (optional).
5 Booklet tray button
Press this button to transfer paper output in booklet tray to retrieval position.
6 Finisher front door
Open this door to clear paper jams, replace staple cartridge and remove jammed staples
and punch scraps.
7 Staple waste container
Collects scraps from the stapler.
8 Side stitch staple cartridge
Cartridge for side stitching.
9 Booklet maker staple cartridges
*1
Cartridge for booklet maker. Two cartridges are provided.
10 Hole punch waste container
Holds the scraps of punched holes.
11 Tri-fold output tray (Envelope Folder Tray)
*2
Outputs paper when [C Fold] or [Z Fold] is selected.
12 Tri-fold output tray button
*2
Press this button to open the tri-fold output tray.
13 Banner Print Extension Tray
*1
Holds banner sheets (paper which is longer than 488 mm in feed length).
*1 : When the Finisher D6 with Booklet Maker is installed
*2 : When the Folder Unit CD2 is installed
z
The Finisher D6 with Booklet Maker is optional. The common features of the C3 Finisher and Finisher D6 with
Booklet Maker described in this guide are referred to as the "finisher".
To Next Page
Loading...
Need help?
General
