Output Format
135
Copy
3
z
Offset Stacking
This option is displayed when you select [Center Tray - Lower] for the output
destination. When an optional finisher is installed, this option is displayed when you
select [Right Middle Tray].
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations. You can select from [Offset per Set], [Offset per
Job], [Offset Every N Pages], [Offset Every N Sets], and [System Default].
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
• If you select [System Default], the setting in the System Administration mode will be
effective. For information on how to change the setting, refer to "5 Tools" > "Copy Service
Settings" > "Copy Defaults" > "Output Destination" in the Administrator Guide.
Paper Size and Stapling Position
z
Finisher-A1
z
Finisher-B1
* : The staple orientation displayed on the touch screen differs from the actual staple orientation. Outputs are stapled
in the orientation shown in the above table.
1 Staple
(Left)
1 Staple
(Right)
A4 , B5 ,
7.25 x 10.5" ,
8.5 x 11"
,
16K
A4, A3, B4,
8.5 x 11",
8.5 x 13"
,
8.5 x 14",
11 x 17", 8K
1 Staple
(Left)
1 Staple
(Right)
2 Staples
(Left)
2 Staples
(Top)
2 Staples
(Right)
A4 , B5 ,
7.25 x 10.5" ,
8 x 10"
,
8.5 x 11" ,
16K
A4, A3, B4,
8.5 x 11",
8.5 x 13"
,
8.5 x 14",
11 x 15",
11 x 17", 8K
* *
*
*
To Next Page
Loading...
