9 Tools
194
Tools
9
[0%] is set at the time of factory shipment.
Off Hook Level
Used to set the level for detecting an off-the-hook receiver when an external phone is
mounted.
You can select from [10 volts], [15 volts], [20 volts], [25 volts], and [35 volts]. [10 volts] is the
lowest extraction level, and [35 volts] is the highest extraction level.
[10 volts] is set at the time of factory shipment.
Note • This setting is only valid when [Region] is set to [Singapore].
Region
Sets the machine's region of use.
You can select from [Unknown], [Australia], [China], [Hong Kong], [Indonesia], Malaysia],
[New Zealand], [Philippines], [Singapore], [South Korea], [Thailand], or [Vietnam].
[Unknown] is set at the time of factory shipment.
Important • If you change the [Region] setting after you have started using the machine, all the settings
including those in Phone Book and reserved fax or other jobs will be reset. Change the [Region]
setting with care.
Note • When [Unknown] is set, it is the only setting displayed under [Fax Settings]. In addition, [Fax] in
[Default Settings] is not displayed.
Follow the steps below to make the settings.
1 In the [Fax Settings] screen, select [Region].
For information on how to display the [Fax Settings] screen, refer to
"System Settings Procedure" (P.162).
2 Press the <OK> button.
3 Select your region, and then press the <OK>
button.
4 Select [Yes (Restart Required)], and then press
the <OK> button.
Restart the machine (turn the power OFF and
then turn it back ON again).
Activity Report
Sets whether the machine automatically prints transmission results (Activity Reports) after
sending and receiving faxes.
[Enable Auto Print] is set at the time of factory shipment.
Off Hook Level
...
10 volts
Fax Settings
Immediate Fax
...
20%
Region
...
Unknown
Australia
China
Region
Unknown
Yes (Restart Required)
Apply Settings [Are You Sure?]
No
To Next Page
Loading...
Need help?
General
