2 Environment Settings
54
Environment Settings
2
z
End of Job Timeout
You can set the time length that the machine waits before terminating the connection
when incoming data stops (between 2 and 3600 seconds). (Default: 60)
z
PDL Switching
[Enabled] is displayed.
îš„ Apply button
You can apply changes by pressing this button.
Note • Reboot the machine to enable new settings.
SMTP Server (Connectivity > Protocols)
You can set the SMTP server.
îš„ Required Information
z
SMTP Server IP Address/Host Name
You can enter the SMTP server's address as an IPv4 or IPv6 address or in FQDN format
(up to 256 characters).
z
Port Number for Sending E-mail
You can set the port number used by the SMTP server to send an e-mail (a value between
1 and 65535). (Default: 25)
z
Login Credentials for the Machine to access the SMTP Server to send automated e-mails
You can set the authentication method when sending an e-mail by SMTP. You can select
[None] or [SMTP AUTH]. (Default: None)
z
Login Name
For SMTP servers requiring authentication, enter the e-mail address of the authenticated
SMTP user (between 1 to 64 ASCII code characters). This can be left blank if SMTP
authentication is skipped.
z
Password
You can enter the password for authentication (between 1 and 64 ASCII code
characters). This can be left blank if SMTP authentication is skipped.
z
Retype Password
You can verify the authentication password you entered by re-entering it here.
îš„ Apply button
You can apply changes by pressing this button.
HTTP (Connectivity > Protocols)
You can set the HTTP protocol.
îš„ Configuration
z
Connection
[Enabled] is displayed.
z
Physical Connection
[Ethernet] is displayed.
z
Keep Alive Timeout
The keep-alive timeout period is displayed.
To Next Page
Loading...
Need help?
General
