Using CentreWare Internet Services
57
Environment Settings
2
You can check [Enabled] to enable IP Filtering. (Default: Off)
z
IP Filter Rule List
The accessible IPv6 address is displayed.
z
Add button
The Add IP Filter Rule - IPv6 screen is displayed. Adds an accessible IPv6 address. You can
add up to 10 IPv6 addresses.
- Source IP Address:
You can set the accessible IP address.
-Source IP Mask:
You can set the prefix length of the accessible IP address. (Default: 0)
z
Edit button
The Edit IP Filter Rule - IPv6 screen is displayed. Edits the accessible IPv6 address.
- Source IP Address:
You can set the accessible IP address. (Default: 0:0:0:0:0:0:0:0)
-Source IP Mask:
You can set the prefix length of the accessible IP address. (Default: 0)
z
Delete button
You can delete the accessible IPv6 address by pressing this button.
îš„ Apply button
You can apply changes by pressing this button.
Note • Reboot the machine to enable new settings.
System Administrator Settings (Security)
You can set the system administrator's user ID and the passcode.
îš„ System Administrator Settings
z
Administrator's Login ID
You can enter the system administrator's user ID (between 1 and 32 ASCII code
characters in length, excludes "+", ";", "<", ">", """, "?", "[", "]", "'", "{", "}", "|", ":". (Default: 11111)
z
Administrator's Passcode
You can set the system administrator's passcode (between 4 and 12 ASCII code
characters or blank). (Default: x-admin)
z
Retype Administrator's Passcode
You need to re-enter the system administrator’s passcode.
z
Maximum Login Attempts
When login attempts using the system administrator’s user ID fail repeatedly, access is
denied when the number of failed attempts reaches the number set here.
Specify a number between 0 and 10. Specify 0 to disable this setting.
The total number of failed authentication attempts is reset when authentication is
successful or the system is restarted. (Default: 5)
îš„ Apply button
You can apply changes by pressing this button.
To Next Page
Loading...
Need help?
General
