To Next Page

To Previous Page

9 Scanner Environment Settings

364

Scanner Environment Settings

5 Select [Close] repeatedly until the [Tools] screen is displayed.

6 Select [Close].

Note • Rebooting the machine may be required depending on the settings. When a message displayed on

the screen, follow the message and reboot the machine.

7 Print a configuration report to confirm that the SOAP, SNMP, and Internet Services (HTTP)

ports are enabled and that TCP/IP is set up correctly.

For information on how to print a configuration report, refer to "Print Reports" (P.108).

Step 2 Configuring the SNMP Port

Configure the transport protocol for the SNMP port using CentreWare Internet Services.

1 Start CentreWare Internet Services.

For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet Services" (P.324).

2 Configure the transport protocol for the SNMP port.

1) Click the [Properties] tab.

2) Click [Connectivity].

3) Click [Port Settings].

4) Select the [UDP] check box under [SNMP].

5) Click [Apply].

6) The right frame of the web browser changes to the machine reboot display.

7) Click [Reboot Machine]. The machine reboots and the settings are enabled.

Step 3 Configuration on the Computer

Create job flows using Device Setup Tool to use for scanned documents.

Note • Device Setup Tool is included in ApeosWare Management Suite, which you can download from our

official web site.

Fuji Xerox docucentre-v c5585 Administrator's Guide

Other manuals for Fuji Xerox docucentre-v c5585