2 Paper and Other Media
56
Paper and Other Media
2
• To prevent paper jams or misloading, do not add paper on top of any remaining paper in the tray.
Remove any paper remaining in the tray, and then load that paper on top of the newly loaded
paper.
2 Remove any paper loaded in the tray.
3 With the side to be copied or printed on facing
up, load approximately 100 to 500 sheets and
align the edges of the paper in the arrow
direction (1). Pinch the long-side paper guide
and slide it to the desired paper size (2).
4 Likewise, load the remaining paper and align
the edges of the paper in the arrow direction
(1). Pinch the left short-side paper guide and
slide it to the desired paper size (2).
Important • Do not load paper exceeding the maximum
fill line. It may cause paper jams or machine
malfunctions.
• If the number of sheets is 100 or less, the
paper guides touch too tightly against the
paper, causing paper to deform and resulting
in paper jams.
• Position the guides correctly to match the
paper size. Otherwise, paper may not be fed
properly, resulting in paper jams.
5 Push the tray in gently until it stops.
Loading Paper in Tray T1 (Inserter)
The following describes the procedure for loading paper in Tray T1 (Inserter) (optional).
1
Hold the center of the paper guides and slide
them to the desired paper size.
To Next Page
Loading...
Need help?
General
