Output Format
117
Copy
3
Select [More] to display the [Paper Supply - Separator] screen on which you can
select a tray.
Note • When you use the bypass tray, select [Tray 5] on the [Separator Tray] screen.
When [Tray 5] is selected, the [Tray 5] screen is displayed. For more information, refer to "[Tray 5]
Screen" (P.79).
Separator & Handout
Allows you to select the paper tray to be used for the separators and handouts.
Select [More] to display the [Paper Supply - Separator & Handout] screen on which
you can select a tray.
Note • When you use the bypass tray, select [Tray 5] on the [Separator & Handout Tray] screen.
When [Tray 5] is selected, the [Tray 5] screen is displayed. For more information, refer to "[Tray 5]
Screen" (P.79).
Handout Tray
Allows you to select the paper tray to be used for the handouts.
Select [More] to display the [Handout Tray] screen on which you can select a tray.
Note • When you use the bypass tray, select [Tray 5] on the [Handout Tray] screen.
When [Tray 5] is selected, the [Tray 5] screen is displayed. For more information, refer to "[Tray 5]
Screen" (P.79).
Copy Output (Specifying Finishing Options)
This feature allows you to select finishing options.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
If the finisher is installed, each set of copies can be stapled, and then output.
1 Select [Copy Output].
2 Select any option.
Auto
Copies are collated when the originals are loaded on the document feeder. Copies are
also collated when the originals are loaded on the document glass and any of the
following features is used: 2 Sided Book Copying, Covers, Blank Separators &
Handouts or Transparency Set & Handouts of Transparency Options, Booklet
Creation, Stapling, Build Job, Sample Set, and Combine Original Sets.
To Next Page
Loading...
