7 Stored Programming
310
Stored Programming
8
1 Select [Store Build Job].
Note • Once a job is stored to a button, it cannot
be overwritten.
• Select [ ] to return to the previous
screen or [ ] to move to the next screen.
2 Select a number to register a stored program.
Note • Once a job is stored to a button, it cannot be overwritten.
• Select [ ] to return to the previous screen or [ ] to move to the next screen.
3 Set the feature you want to register.
Note • The machine sounds an audible tone while a stored program is being registered.
• Press the <Interrupt> button to cancel registration.
You can change the volume of the sound that notifies that a stored program is being registered. For
information on the settings, refer to "5 Tools" > "Common Service Settings" > "Audio Tones" > "Stored
Programming Tone" in the Administrator Guide.
4 Press the <Start> or <Clear All> button.
Note • An icon is displayed to the left of each registered stored program for Build Job.
• If no name is entered for a registered stored program, the name becomes “No Name”.
For information on how to name a registered stored program, refer to "Entering/Changing a Stored
Program Name" (P.311).
Deleting Stored Programs
The following describes how to delete stored programs.
1 Select [Delete].
2 Select the number to deleted.
Note • Select [ ] to return to the previous screen or [ ] to move to the next screen.
3 Select [Delete].
Delete
Deletes the stored program.
To Next Page
Loading...
