Fuji Xerox DocuPrint CM505 da - ID Card Copy (Copying both Sides of an ID Card)

Output Format
119
Copy
3
Paper Size and Stapling Position
z
Finisher-AB1
* : The staple orientation displayed on the touch screen differs from the actual staple orientation. Outputs are stapled in
the orientation shown in the above table.
* : When different sized documents are loaded in the document feeder, outputs are stapled only when all the documents
match the document guides.For information on how to copy different sized documents simultaneously, refer to "Mixed
Size Originals (Scanning Different Size Documents Simultaneously)" (P.99)
ID Card Copy (Copying Both Sides of an ID Card)
This feature allows you to copy both sides of a small undetectable original, such as an
ID card, onto one side of paper.
1 Specify the orientation of the document in
[Original Orientation] on the [Layout
Adjustment] screen.
2 Place the document slightly away from the top left corner of the document glass, and
close the document glass.
Important • Always use the document glass when copying. You cannot use the document feeder with
this feature.
• Specify the orientation of the original document correctly.
• If the edges of the image are missing, slightly move the card inward on the document glass
so that the whole image can be scanned.
1 Staple
(Left)
1 Staple
(Right)
A4, B5,
7.25 x 10.5",
8.5 x 10"
,
8.5 x 11",
8.5 x 13",
8.5 x 14",
16K
Original document
Front side
Back side
Original orientation
Copied output
Front side
Back side