Printing Basics 119
• If envelopes are still not fed correctly, add some bending to the flap of the envelopes as shown in the following
illustration.
The amount of the bending shall be 5 mm (0.20 inches) or less.
• To confirm the correct orientation of envelopes, see the instruction on the Envelope/Paper Setup Wizard on
the print driver.
Loading Postcard in the Multipurpose Feeder
NOTE:
• When you print on postcards, be sure to specify the postcard setting on the print driver to get the optimum
print result.
• When Loading Postcard
Load the postcard with the side to be printed on facing up, and the top edge of the postcard in first.
To Next Page
Loading...
