158 Using the Operator Panel Menus
USB Setup
Use the USB Setup menu to change printer settings affecting a USB port.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
•Port Status
Purpose:
To change the USB settings on your printer. The change becomes effective after the printer is turned
off and then on.
Values:
System Setup
Use the
System Setup
menu to
specify the various basic settings for the printer.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• PowerSaver Time
Purpose:
To specify the time for transition to Power Saver Mode.
Values:
Select 5min. (default) for Mode1 if your printer shares an electrical circuit with your room lights and
you notice them flickering. Otherwise, select a high value to keep your printer available for frequent
use with the minimum warm-up time.
The printer automatically returns to the standby mode from the Power Saver Mode when it receives
data from the computer. In Mode1, you can also return the printer to the standby mode by pressing
any button on the operator panel. In Mode2, you can return the printer to the standby mode by
pressing the (Energy Saver) button.
Disable Disables the USB interface.
Enable* Enables the USB interface.
Mode1 5min.* Specifies the time taken by the printer before it enters Mode1
after it finishes a job.
5–30min.
Mode2 6min.* Specifies the time taken by the printer before it enters Mode2
after it goes into Mode1.
1–6min.
To Next Page
Loading...
Need help?
General
