170 Using the Operator Panel Menus
Resetting to Factory Defaults
After executing Initialize NVM and rebooting the printer, all the menu parameters are reset to
their default values.
The following menu parameters are exceptions and are not reset.
• Network Setup
• Secure Settings
• USB Setup
NOTE:
• The Network Setup settings can be reset by executing Reset Defaults. For more information, see
"Reset Defaults" on page 157.
1 Press the (Menu) button.
2 Select Admin Menu, and then press the
button.
3 Select Maintenance Mode, and then press the
button.
4 Select Initialize NVM, and then press the
button.
5 Confirm that Are you sure? appears, and then press the
button. The printer starts
initializing the Non-Volatile Memory (NVM).
6 When the Initialized. message appears, turn off and then on the printer to apply the
settings.
To Next Page
Loading...
