Troubleshooting 187
Random Spots/Blurred Images
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji
Xerox local representative office or an authorized dealer.
The Entire Output Is Blank
If this trouble happens, contact the Fuji Xerox local representative office or an authorized dealer.
Problem Action
The printed result has random
spots or is blurred.
Make sure that the toner cartridges are installed correctly.
See also:
•"Installing a Toner Cartridge" on page 222
If you use non-genuine brand toner cartridges, install genuine brand
toner cartridges.
Clean up the fusing unit.
1 Load one sheet of paper on the multipurpose feeder, and then print
a solid image all over paper.
2 Load the printed sheet with the printed side facing down, and then
print a blank sheet of paper.
To Next Page
Loading...
