312
Home > Network > Additional Methods of Configuring Your Fuji Xerox Machine for a Wireless Network >
Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup
™
(WPS)
Configure Your Machine for a Wireless Network Using the One Push
Method of Wi-Fi Protected Setup
™
(WPS)
If your wireless access point/router supports WPS (Push Button Configuration), you can use WPS from your
machine's control panel menu to configure your wireless network settings.
Routers or access points that support WPS are marked with this symbol:
1.
Press [Settings] > [All Settings] > [Network] > [WLAN] > [WPS].
2.
When [Enable WLAN?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
3.
When the touchscreen displays [Start WPS on your wireless access point/router, then
press [OK].], press the WPS button on your wireless access point/router. Then press [OK] on your
machine. Your machine will automatically detect your wireless access point/router and try to connect to your
wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
You have completed the wireless network setup. To install drivers and software necessary for operating your
device, insert the Fuji Xerox installation disc to your computer or go to the download page for your model on the
Fuji Xerox website at http://www.fujixerox.com
.
• Additional Methods of Configuring Your Fuji Xerox Machine for a Wireless Network
Related Topics
• Wireless LAN Report Error Codes
Related Models: DocuPrint M385 z/DocuPrint M375 z
To Next Page
Loading...
Need help?
General
