114 Using the Operator Panel Menus
•PS Job Time-out
Purpose:
To specify the runtime of one PostScript
®
job. The change becomes effective after the printer is turned off and then on
again.
Values:
•PaperSelect Mode
Purpose:
To set the way to select the paper tray for PostScript
®
mode. The change becomes effective after the printer is turned off
and then on again.
Values:
Network Setup
Use the Network Setup menu to change the printer settings affecting jobs sent to the printer through the network.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
•Ethernet
NOTE:
• Ethernet feature is available only when the printer is connected using the wired network.
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the printer is
turned off and then on again.
Values:
•Wireless Status
NOTE:
• Wireless Status feature is available only when the printer is connected using the wireless network.
Purpose:
To confirm the wireless communication status.
Values:
Off* Job time-out does not occur.
On 1min A PostScript
®
error occurs if processing is not completed after the specified
time.
1-900min
Auto* The tray is selected as the same setting as in the PCL mode.
Select FromTray The tray is selected in a method compatible with regular PostScript
®
printers.
Auto
*
Detects the Ethernet settings automatically.
10BASE-T Half Uses 10BASE-T Half-duplex.
10BASE-T Full Uses 10BASE-T Full-duplex.
100BASE-TX Half Uses 100BASE-TX Half-duplex.
100BASE-TX Full Uses 100BASE-TX Full-duplex.
1000BASE-T Full Uses 1000BASE-T Full-duplex.
Connection Displays the connection condition.
Encryption Type Displays the encryption type.
To Next Page
Loading...
