Maintenance 209
9
Insert the bypass tray into the printer, push until it stops, and close the cover.
10
Reconnect all cables into the rear of the printer and turn on the printer.
Removing the Optional Wireless Printer Adapter
IMPORTANT:
• If you remove the optional wireless printer adapter, be sure to turn off the printer, unplug the power cord, and disconnect all cables
from the rear of the printer before removing the adapter.
1
Turn off the printer.
IMPORTANT:
• Note that the data in the memory are cleared when the printer is turned off.
2
Disconnect the power cord from the power connector on the rear of the printer.
3
Turn the screw on the control board cover counterclockwise.
To Next Page
Loading...
Need help?
General
