Connecting external devices
440 N00072 41
Connecting USB devices
On the USB ports you can connect external devices that also have a USB port (e.g. a printer, a
scanner or a modem).
i
USB devices are hot-pluggable. This allows cables from USB devices to be connected
and disconnected with the system switched on.
USB 1.x has a maximum data transfer rate of 12 Mbit / s.
USB 2.x has a data transfer rate of up to 480 Mbit / s.
Additional information can be found in the documentation for the USB devices.
Ê Connect the data cable to the external device.
Ê Connect the data cable to a USB port of the notebook.
i
Device drivers
The devices you connect to the USB ports usually require no driver of their own, as the
required software is already included in the operating system. However, if the USB device
requires its own software, please install it from the data carrier provided with the USB
device.
Connecting external audio devices
Headphones port
Via the headphone port you can connect either headphones or external loudspeakers to your
notebook.
Microphone jack
Via the microphone port you can connect an external microphone to your notebook.
Adjusting the volume
Ê Adjust the desired volume on the volume
control (see “Views“ – “Left side panel“).
Ê To turn the loudspeakers on or off, press
[Fn] and [F5].
Or
Ê To adjust the volume use the Windows volume control from the Start menu – Programs -
Accessories – Multimedia – Volume Control.
Ê To switch the loudspeakers on and off use the Windows volume control from the Start menu –
Programs – Accessories – Multimedia – Volume Control.
To Next Page
Loading...
Need help?
General
