Fujitsu 5GRUDB3 - Unpack

4.1
Unpack
When unpacking the RU, do not remove the foam blocks aached to the antenna connectors, as the foam
protects the antenna connectors during installation.
Warning: While unpacking the RU, do not remove the foam blocks
aached to the antenna connectors, as the foam protects the
antenna connectors during installation.
Avertissement: Lors du déballage du RU, ne retirez pas les blocs de
mousse aachés aux connecteurs d'antenne, car la mousse protège
les connecteurs d'antenne lors de l'installation.
Note: If the RU is not being installed immediately aer unpacking, keep the caps on the connectors of the RU
and store it in an area protected from rain and water in accordance with
Transport and Storage Requirements.
To unpack the shipping package:
Step 1
Open the shipping package and carefully remove the contents.
Step 2
Place the RU on packing foam or an anti-static mat.
Step 3
Remove all packing foam that is around the heat sink and unit.
✓ is task is complete.
Installation
Unpack
85
Release 1.0 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only