Working with the notebook
Wireless LAN / Bluetooth (device-dependent) /
UMTS / LTE (device-dependent
)
The installation of a radio components not approved by Fujitsu Technology
Solutions will invalidate the certifications issued for this device.
Switching the wireless components on and off
Before switching on your device for t he first time, the on/off switch for
radio components must be in the "ON" position.
► Slide the O N/O FF switch into the "ON"
position to activate the radio components.
Wireless LANWireless LANBluetoothBluetooth
or
► Slide the ON/OFF sw
itch to the
"OFF" position to
deactivate the
radio com ponents
.
If you switch off the radio compo nents, the wireless LAN antenna and (when present)
the Bluetooth and UM TS / LTE modules will also be switched off.
You can enable and disable the installed radio components individually
using the WirelessSelector programme
You can also deactivate the wireless c ompo nents individually in the BIO S Setup.
For th is to occur, you must either not ha ve assigned a supervisor password or if a
supervisor password has been assigned, you must know this password.
Pay attention to the additional safety notes for devices with radio components
provided in the "Safety/Regulations" manua l.
Details on using Wireless LAN can be found in the online help system
included in the Wireless LAN softwa re.
You can find more information on how to use Bluetooth on the CD you
received with your Bluetooth software.
You can obtain more information o n UMTS / LTE from your service provider.
44 Fujitsu Technology Solutions
To Next Page
Loading...
