Manufacturer’s notes
FCC regulatory information for notebooks with radio device
Regulatoryinf ormation
Federal Communications Commission statement
This device complies with P art 15 of FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of this device.
FCC Interference Statement
This equ ipment has been tested and found to comply with the limits for a Class B digital
device, pursu ant to Part 15 of the FCC Rules. These limits are designed to p rovide reasonable
protection against harmful interferen ce in a residential installation. This equipment generates,
uses, and can radiate radio f requen cy energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to ra dio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equ ipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the distance between the equipment and the receiver.
3. Connect the equipment to an outlet on a circuit different from the one the receiver is connect ed to.
4. Consult the dealer or an experienced radio/TV technician f or help.
Please no te the following regulatory information related to the optional radio device.
FCC Radio Frequency Exposure statement
This radio device has bee n evaluated under FCC Bulletin OET 65C and found compliant with the
requirements as set forth in CF R 47 Sections 2.1091, 2.1093, and 15.247 (b) (4) addressing RF
Exposure f rom radio frequency d evices. The radiated output power of this radio device is far below
the F CC radio frequ ency exposure limits. Nevertheless, this device shall be used in such a manner
that the potential for h uman contact during normal operation is minimized. When using this device, a
certain separation distance between antenna and nearby persons must be maintained to ensure RF
exposure compliance. In order to comply with R F e xposure limits established in the ANSI C95.1
standards, the distance between the antennas and the user should no t be less than 20 cm (8 inches).
Regulatory Notes and Statements
Radio device, health and authorisation for use
Radio-frequency electromagnetic energy is emitted from the wireless devices. The energy levels
of these emissions, however, are far much less than the electromagnetic energy emissions from
wireless devices such as mobile phones. Ra dio devices are safe for use by consumers because
they operate within the guidelines found in radio frequen cy safety standards and recommendations.
The use of the radio devices may be restricted in some situations or environments, such as:
• on board an airplane, or
• in an explosive environment, or
• in situations where the interference risk to other devices or services is
perceived or identi fied as ha rmful.
In cases in which the policy regarding use of radio devices in specific environments is not
clear (e.g., airports, hospitals, chemical/oil/gas industrial plants, private buildings), obtain
authorization to use these devices prior to operating the equipment.
90 Fujitsu Technology Solutions
To Next Page
Loading...
