Removing and installing components
during servicing
Attaching the cover
2
1
► Place the cover in the correct mounting position (1).
If you remove more than one component at the same time, keep the screws for the
individual components separately from each other and make sure that you use the
correct screws. If you install the wrong screws, componen ts may be damaged.
► Tighten the screw (2).
► In ser t the battery (see Chapter "
Install ing a b attery", Page 32).
Finishing component removal
After you have remo ved or changed the system com ponents as you required, please
prepare your device for operation again as follows:
► Install the battery again (see "
Installing a battery", Page 32).
► Turn the notebook the right way up again and place it on a flat surface.
► R eco nnect the cables that you disconnected before.
72 Fujitsu Technology Solutions
To Next Page
Loading...
