EasyManua.ls Logo

Fujitsu CELSIUS H720 - Port Replicator (Optional) Specifications

Fujitsu CELSIUS H720
99 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting and tips
Error messages on the screen
Errormess agesonthe screenErrormessage:
This section describes the error messages generated by the BIOS Set up. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, p lease
contact the place of purchase or o ur customer service centre.
Error message/cause Resolution
CMOS battery bad
If the error message occurs repeatedly, the
buffer battery in the notebook is at.
Contact your sales outlet
or our customer
service centre.
System CMOS checksum bad - default conguration
used
The system conguration information is
incorrect.
Switch the notebook of
f.
Switch the notebook on.
Press the function k
ey
F2
to access the
BIOS Setup.
In the BIOS Setup, select the Exit menu.
Select the entry Lo
ad Setup De faults.
Select OK and press the Enter key.
Extended memory failed at o ffset: xxxx Failing B its:
zzzz zzzz
When testing the extended memory an error has
resulted at the address xxxx.
Check wh ether the add itional memory
module has been inserted correctly.
Failure Fixed Disk n
The settings of the hard disk drive a re incorrect.
Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
Keyboard controller error
Switch the n otebook off with the O N /O FF
switch.
Wait 3 - 5 seconds and switch on the
notebook again.
Keyboard error
If you are using an external keyboard:
Check the connection and reboot the
notebook.
nn Stuck key
Make sure that no key is pressed.
Operating system n ot found
Check
in the BIOS Se tup whether your hard
disk h
as been set correctly.
Make sure that the operating system is
installed on the corresponding drive.
Press <F1> to resume, <F 2> to S ETUP
This error message appears if an error occurs
during the self-test before starting the operating
system.
Press the
F1
function k ey to start the
operating system.
Press the function key
F2
to access the
BIOS Setup.
80 Fujitsu Technology Solutions

Table of Contents

Other manuals for Fujitsu CELSIUS H720

Related product manuals