Working with the notebook
Connecting the mains adapter to the Port Replicator
1
2
3
► Connect the mains adap ter cable to the D C
jack (DC IN) of the Port Replicator (1).
► Connect the power cable to the
mains a d apter (2).
► Plug the power cable into the mains
socket (3).
When the notebook is connected to a Port Replicato r, the operating system creates
a hardw are profile for the "Docked" mode. In this profile, for example, the setting is
saved a s to which monitor was last used for output. This profile will be loaded, as
soon as the notebook is connected to a Port Replicator of the same type.
Switching on the notebook via the port replicator
► Press the ON/O F F switch on the port
replicator to switch th e notebook on.
The power-on indicator of the Port
Replicator lights up.
Switching off notebook via Port Replicator
► Close all applications and shut down your operating system (please refer
to the m anual for the operating system).
If the noteboo k cannot be shut do wn prop erly, press the ON /OF F button
on the P ort R eplicator for approx. four seconds. The note book will switch
off. Any unsa ved data may however be lost.
48 Fujitsu Technology Solutions
To Next Page
Loading...
